|
|
|
|
Options. Select the check boxes of the Test options you want to enable.
|
|
|
Disregard Any Errors
|
When selected, e-mail and page notifications are not sent in the event of a Test error, and testing continues as normal.
|
|
Notify Always
|
Always send a notification for any error condition. Use this option when you want to be notified for any Test error.
|
|
Include on Alerts Page
|
When selected, the Test's error information is listed when All
Alerts or All Production Alerts
are selected from View Group/Monitors
in the Reveille Web interface.
In the event you are monitoring a business process, you may not want
to select this option because these alert pages indicate system problems,
not business process problems.
|
|
Graph Response Times
|
When selected, Resource response times for the Test are included in the Response Time graph
in the Reveille Web interface.
|
|
Notify Again
|
Send a notification if a different error occurs. Use this option when you want to be notified when a Test error occurs that is different from the previous error for the same Test.
Note: If the Notify Again option is checked
and the Test has detected an error state, the following will occur: The
next time the Test runs, the Monitor compares the full new error message
(Test response) to the previously saved error message. If these are different,
then all notification flags are reset, causing notification at each level.
The notification message used is the new generated short message, not the
one currently stored in the database (ErrorMsg2). Normally
ErrorMsg2, which can be edited in Error Maintenance, is used. Because
of the Notify Again option, the
new error message will be used for notification.
|
|
On Critical Error. Enables you
to either
Stop Further Tests or Continue Testing.
|
|
|
Stop Further Tests
|
All testing dependent on this
resource stops if an error occurs. The
Resource Test on the application diagram will change to RED on error.
|
|
Continue Testing
|
All testing dependent on this
resource continues if an error occurs. The Resource Test on the application
diagram will change to RED on error.
|
|
Disable. Enables you
to disable the Test or the notification to support personnel should an
error occur.
|
|
|
Test
|
Select
to disable the Test.
|
|
Notification
|
Select
to not
notify support personnel if an error occurs for the Test.
|
|
Run This Test. Enables you
to set when to run the selected Test.
|
|
|
ALWAYS IF RESOURCE Tested
|
Select
to run the Test regardless of additional errors occurring on this Resource.
|
|
On RESOURCE Error(s) ONLY
|
Select
to run the Test only if errors exist on the Resource.
|
|
On MONITOR Error(s) ONLY
|
Select
to run the Test only if errors exist on either this or other Resources
specified under the Monitor.
|
|
Status Metric. Enables you to select a Metric to be used for test evaluation based on test status for the Last N Times or Number of Occurrences over the Last N Minutes. The Status Metric is automatically processed at the end of normal Metric Test evaluation.
|
|
|
Evaluate this Test using the following Metric
|
Select to use a Metric for test evaluation. Select the Metric from the dropdown list, or click  browse to define a new Metric.
|
|
Test Metrics. Enables you to see which Metrics are currently being used by the Test.
|
|
|
This Test uses the following Metrics
|
Displays all the Metrics being used by the Test. Double-click a Metric in the list to view or edit the Metric.
|